Sprinklers: FAQ About Irrigation Systems

Summer is here, and that means sprinklers and irrigation systems everywhere are running at full blast. Problems can arise, however, and you might not know the answers. Before calling a contractor, read on for some of the most common questions about these watering devices.

How long should I water my lawn and garden?

This depends on your sprinkler system and its Bec tuoi phun mua precipitation rate. A typical spray run will water shrubs for 10 minutes, circle rotors for a half hour and full circle rotors for a full hour. Contact your local sprinkler installer to have your program set up.

What does a sprinkler system consist of?

The system efficiently waters your yard with sprinkler heads (spray or rotary) placed in a geometric pattern. It’s separated into zones to make the best use of water pressure and because your lawn’s watering needs vary by location. The final piece is a controller or timer that dictates to the system when it operates.

My sprinklers won’t turn off.

Try unplugging the controller. If this does the trick, follow the manufacturer’s directions to reprogram the controller. Should the system not turn off, then turn off the water to the sprinklers and contact your sprinkler system company.

Do sprinklers conserve water?

Yes. One of the best reasons for getting an automatic irrigation system is they excel at water conservation. A system installed and maintained properly ensures total hydration coverage; and the correct water distribution, timing and calibration. The best time to water your plants is in the morning, as there is ample time for water to penetrate the ground, calmer wind and peak water pressure.

Are rain sensors a good investment?

Rain sensors are one of the best ways to save water, as well as extend your system’s life. Plus, they allow your sprinklers to take a break when rain falls, so investigate adding one to your irrigation system.

Why is my rotary sprinkler not rotating?

If the sprinkler is no longer rotating or water flow has decreased, it could be the filter is clogged, so try cleaning it out. If this doesn’t solve the issue, then the internal assembly probably needs replaced.


Leave a Reply

Your email address will not be published. Required fields are marked *